RADIATOR & COMPONENTS. 2013-2016.. 2013 Audi allroad 2.0L FLEX A/T

2013-2016.

Left.2013-2016. Radiator mount bolt. Right.2013-2016. Radiator Mount Bolt. Radiator Support Tie Bar Bolt. Auxiliary Radiator. Frame. Insulator. Retainer. Stud. Support bracket. Tie Bar.

Left.2013-2016. Right.2013-2016.

Left.2013-2016. Right.2013-2016.

Left.2013-2016. Right.2013-2016.

Left.2013-2016. Right.2013-2016.

Left.2013-2016. Lower mount upper bolt. Right.2013-2016. A threaded rod with a drive head (such as hex, 12 point, torx, etc) on one end used to secure the Headlamp Mounting Panel to it's Mounting point. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Radiator Support Panel Reinforcement to a Mounting point. Bumper Cover Spacer Panel Bolt. Bumper Impact Bar Bolt. Headlight Mounting Bolt. Radiator Mount Bolt. Radiator Support Panel Bolt. Radiator Support Splash Shield Bolt. Valance Panel Bolt.

Left.2013-2016. Lower mount lower bolt. Right.2013-2016. A Bolt which attaches the door panel carrier to its Mounting point. A Screw that is used to secure the Bumper Cover Stay to it's Mounting point. A Screw that is used to secure the Radiator to its Mounting point. A Screw used to secure the turbo boost sensor to its Mounting surface. A threaded rod with a drive head (such as hex, 12 point, torx, etc.) on one end used to secure the Turbocharger Boost Sensor to it's Mounting point. Body A-Pillar Trim Panel Screw. Door Interior Trim Panel Screw. Door Sill Plate Bolt. Grille Screw. Radiator Mount Bolt. Included with: Connector tube, Front sensor, Intercooler, Rear sensor.

Air duct. Right.2013-2016.

Air duct. Left.2013-2016.

2013-2016. Lower seal strip. Rubber Seal at center of Radiator support. Seal used on the Radiator. Air. Gasket. Ing. Outer. Side. Support Panel.

2013-2016. Reservoir.

2013-2016. A cover that prevents foreign debris from entering the container. Cap for the Hybrid Inverter Coolant Reservoir. Includes: Expansion Tank Cap Seal. Location-Auxiliary Reservoir. Location-Primary Reservoir. Location-Reservoir. Radiator Cap. To 09/30/2013. Cover. Drive Motor Inverter Coolant. Engine Coolant. Expansion Tank. Radiator. Included with: Reservoir.

2013-2016. Reservoir cap gasket. 28.5 x 3.8mm. A circular disk covered in rubber or plastic with a hole in the center where the edge is sometimes tensioned by a spring that prevents fluid from leaking at the Engine Coolant Expansion Tank Cap. A circular disk covered in rubber or plastic with a hole in the center where the edge is sometimes tensioned by a spring that prevents fluid from leaking at the Engine Coolant Expansion Tank Hose. A component which provides a sealing surface at the Engine Coolant Overflow Reservoir Cap. Engine Coolant Reservoir Seal. O-Ring. Part serviced with reservoir cap. Seal used on the Radiator. Gasket. Overflow Hose. Pipe O - Ring. washer. Radiator Air. Included with: Cap, Cover, Reservoir cap.

2013-2016. Air Filter Housing Grommet. Air Filter Housing Insulator. Grommet through which a portion of the expansion tank fits when mounted to vehicle. Cleaner Assembly Insulator. Engine Coolant Recovery Tank. Filter Housing Insulator. Mount bushing. Reservoir cap. Included with: Air Cleaner Assembly.

2013-2016.

2013-2016.

2013-2016. 32 x 4mm. A circular disk covered in rubber or plastic with a hole in the center where the edge is sometimes tensioned by a spRing that prevents fluid from leaking at the Engine Coolant Temperature Sensor. A round Ring used to Seal between the Radiator Hose and it's mounting surface. At Radiator. Cooling System Bypass Line Adapter O-Ring. Engine Coolant Bypass Pipe O-Ring. Engine Coolant Thermostat Housing O-Ring. Engine Coolant Thermostat Housing Seal. Lower Radiator Coolant Hose. O-Ring. Primary Radiator. Radiator Coolant Hose Seal. Upper Radiator Coolant Hose. Included with: Adapter, Coupling, Coupling body, Lower Coupling, Lower Hose, Lower Hose Part cannot be reused/reinstalled, Lower Hose Coupling, T-piece, Thermostat unit, Upper Coupling, Upper Hose, Upper Hose Part cannot be reused/reinstalled, Water Hose assembly.

2013-2016. "A ""C"" shaped Clip which helps to hold or retain the Coolant Pipe to it's mounting point.". A "C" shaped Clip which helps to hold or retain the Engine Coolant Temperature Sensor. A "C" shaped Clip which helps to hold or retain the Radiator Hose. A "C" shaped Clip which helps to hold or retain the Thermostat Housing to it's mounting point. At Radiator. Clip used in the securing/routing of the Radiator Coolant Hose. Engine Coolant Pipe Clip. Primary Radiator. Included with: Adapter, Coupling, Hose and tube assembly, Lower Coupling, Lower Hose, Lower Hose Part cannot be reused/reinstalled, T-piece, Thermostat unit, Upper Coupling, Upper Hose, Upper Hose Part cannot be reused/reinstalled, Water Hose assembly.

2013-2016. A round Ring used to Seal between the Radiator Hose and it's mounting surface. At Water Pump Housing. Cooling System Bypass Line Adapter O-Ring. Engine Cooling Radiator. Lower Radiator Coolant Hose. Primary Radiator. Radiator Coolant Hose Seal. Center pipe. Connector o -. Cooling System Bypass Line Adapter O -. Coupling o -. Inlet o -. Radiator Coolant O -. Return o -. Included with: Connector Hose, Connector tube, Inlet Hose, Lower Coupling, Lower Hose, Lower Hose Part cannot be reused/reinstalled, Lower rear Hose, Upper Hose, Upper Hose Part cannot be reused/reinstalled.

2013-2016. A "C" shaped Clip which helps to hold or retain the Radiator Hose. At Water Pump Housing. Clip used in the securing/routing of the Radiator Coolant Hose. Engine Coolant Pipe Clip. Engine Cooling Radiator. Primary Radiator. Adapter. Connector. Coupling. Engine Coolant Pipe. Holder. Inlet. Radiator Coolant C -. Return. Water manifold. Included with: Connector Hose, Connector tube, Inlet Hose, Lower Coupling, Lower Hose, Lower Hose Part cannot be reused/reinstalled, Lower rear Hose, Upper Hose, Upper Hose Part cannot be reused/reinstalled.

2013-2016. Overflow hose. to 04/06/2012.

2013-2016. from 04/09/2012. Overflow hose.

2013-2016.

2013-2016. 32 x 4mm. A circular disk covered in rubber or plastic with a hole in the center where the edge is sometimes tensioned by a spRing that prevents fluid from leaking at the Engine Coolant Temperature Sensor. A round Ring used to Seal between the Radiator Hose and it's mounting surface. At Radiator. Cooling System Bypass Line Adapter O-Ring. Engine Coolant Bypass Pipe O-Ring. Engine Coolant Thermostat Housing O-Ring. Engine Coolant Thermostat Housing Seal. Lower Radiator Coolant Hose. O-Ring. Primary Radiator. Radiator Coolant Hose Seal. Upper Radiator Coolant Hose. Included with: Adapter, Coupling, Coupling body, Lower Coupling, Lower Hose, Lower Hose Part cannot be reused/reinstalled, Lower Hose Coupling, T-piece, Thermostat unit, Upper Coupling, Upper Hose, Upper Hose Part cannot be reused/reinstalled, Water Hose assembly.

2013-2016. "A ""C"" shaped Clip which helps to hold or retain the Coolant Pipe to it's mounting point.". A "C" shaped Clip which helps to hold or retain the Engine Coolant Temperature Sensor. A "C" shaped Clip which helps to hold or retain the Radiator Hose. A "C" shaped Clip which helps to hold or retain the Thermostat Housing to it's mounting point. At Radiator. Clip used in the securing/routing of the Radiator Coolant Hose. Engine Coolant Pipe Clip. Primary Radiator. Included with: Adapter, Coupling, Hose and tube assembly, Lower Coupling, Lower Hose, Lower Hose Part cannot be reused/reinstalled, T-piece, Thermostat unit, Upper Coupling, Upper Hose, Upper Hose Part cannot be reused/reinstalled, Water Hose assembly.

2013-2016. Lower hose holder. Clip used in the securing/routing of the Radiator Coolant Hose. Lower Radiator Coolant Hose. Plastic or Steel, wraps around the Radiator Hose to keep it in a stationary position. Not to be confused with a bracket or mount. Radiator Coolant Hose Bracket. Radiator Hose Clamp. Bracket. Clamp. Clip. Hold Down. Holder. Support. Included with: Lower Hose.

2013-2016. 40 x 12mm. At Radiator and Adapters. Auxiliary Radiator. Engine Coolant Bypass Pipe Clamp. Engine Coolant Pipe Clamp. From Chassis/VIN 3C-7-120 001. Fuel Filler Hose Clamp. InterCooler Pipe Clamp. Lower Radiator Coolant Hose. Primary Radiator. Radiator Hose Clamp. Radiator Location-Front. To Chassis/VIN 3C-7-120 000. Upper Radiator Coolant Hose. Included with: Hose & tube assembly, Hose and tube assembly, Hose assembly, Lower coupling, Lower Hose, Lower Hose Part cannot be reused/reinstalled, Rear Hose, Upper Hose, Upper Hose Part cannot be reused/reinstalled, Upper Hose and Lower Hose, Water Hose, Water Hose assembly.